Browsed by
Tag: pipe relining

Pipe Relining Sydney Agencies Can Repair Damaged Underground Drainage Pipes Without Digging Trenches

Pipe Relining Sydney Agencies Can Repair Damaged Underground Drainage Pipes Without Digging Trenches

You need a proper pipe relining Sydney for drainage that ensures that all the wastewater from the usage of your plumbing system is safely carried out of your home to municipal sewers or septic tanks. Over time and with repeated use, the inside of these pipes can get damaged, due to various reasons, and require them to be repaired.

Traditionally, these repair works were carried out by digging trenches to access the damaged section of the pipe, and then removing it and replacing it with a new section. This process can lead to a lot of mess and disruption. Pipe relining or cured-in-place pipelining (CIPP) can arrange for this replacement without any need for any digging of trenches. This technology allows repairs to be carried out even when the pipes have suffered substantial damage.

Pipe relining Sydney agencies like Dr. DRiP Plumbing will repair the pipes by using a special resin that cures with time and forms a pipe, that is often much stronger than the original. Pipe relining is considered a trenchless technology as the process is carried out without digging up any trenches. It is a process that is more cost-effective than the traditional ways of replacing pipes by the “dig and repair” method. In the CIPP method, a seamless flexible textile tube is saturated with resin and inserted into the damaged section of pipe. This resin hardens and forms a new pipe inside the old pipe. Insertions of these resin-impregnated pipes should preferably be made upstream of the damaged area.

Before any pipe relining Sydney is attempted, it is necessary to inspect the pipes to understand the extent and location of the damage. This can be done through closed-circuit cameras inserted into the pipes or by other leak location electron equipment. After this, all flow of wastewater into this damaged section must be stopped and the pipe section must be cleared of all blockages, preferably by hydro jetting that can also ensure that the pipes will then have a surface on which the resin can easily set. The pipe must then again be inspected to ensure that it is ready for the relining. This inspection will allow determination of the length of the pipe that needs to be relined and the extent of the damage in it.

A length of the chosen flexible liner is then soaked in resin. The length of the pipe should be a little longer than the damaged section so that there is sufficient overlap. This pipe is then inserted into the damaged pipe through manholes or other access points at a point upstream of the portion needing repairs. Compressed air allows this pipe to expand and press against the walls of the damaged pipe. This pressure needs to be maintained until the resin cures and sets. Curing can be accelerated by using hot water to allow the job to be completed in one day. Some pipe relining Sydney agencies may also use UV radiation to complete the hardness of the new pipe.

Relined pipes can have a life expectancy of 50 years. It is also better if the pipe is again inspected by cameras before that section is released for use.